Underfloor Heating in Swords, Dublin
Compare underfloor heating professionals in Swords. Free quotes, no obligation.
Swords is one of Dublin's largest and fastest-growing towns. Housing is predominantly 1990s to 2010s estates in areas like Applewood, Holywell, Boroimhe, River Valley, and Rathingle, with thousands of relatively modern semi-detached and terraced homes. Older housing near Swords village dates from the 1970s-80s. The volume of similar-age housing (15 to 25 years old) creates concentrated demand for mid-life upgrades. Large numbers of apartments have been built near the Pavilions shopping centre. New housing continues on the expanding edges of the town.
Managed by Fingal County Council. Swords is designated for significant growth under the Fingal Development Plan, with MetroLink planned to connect it to the city centre. The inland north Dublin location is relatively sheltered. Modern housing estates have reasonable insulation but earlier 1990s builds may fall short of current standards. Flat terrain means good solar exposure. Property values of €300k to €500k make upgrades affordable. The volume of work available creates competitive pricing among contractors.
Underfloor Heating in Swords: Local Insights
Swords is one of Dublin's largest and fastest-growing towns. Housing is predominantly 1990s to 2010s estates in areas like Applewood, Holywell, Boroimhe, River Valley, and Rathingle, with thousands of relatively modern semi-detached and terraced homes. Older housing near Swords village dates from the 1970s-80s. The volume of similar-age housing (15 to 25 years old) creates concentrated demand for mid-life upgrades. Large numbers of apartments have been built near the Pavilions shopping centre. New housing continues on the expanding edges of the town.
Managed by Fingal County Council. Swords is designated for significant growth under the Fingal Development Plan, with MetroLink planned to connect it to the city centre. The inland north Dublin location is relatively sheltered. Modern housing estates have reasonable insulation but earlier 1990s builds may fall short of current standards. Flat terrain means good solar exposure. Property values of €300k to €500k make upgrades affordable. The volume of work available creates competitive pricing among contractors.
Underfloor Heating Costs in Swords
Typical costs for underfloor heating in the Swords area (Dublin pricing applies):
| Service | Typical Cost | Notes |
|---|---|---|
| Electric UFH (per sq m) | €75 | €120 | Area, thermostat |
| Wet UFH (per sq m) | €120 | €195 | System design, manifold |
| Wet UFH full house (new build) | €7,500 | €15,000 | Property size, zones |
Dublin area estimates, 2026. Request quotes for accurate pricing.
Underfloor Heating FAQs
Wet underfloor heating in a new build or extension costs €40 to €70 per square metre for supply and installation, where the screed is being poured anyway. Retrofit wet systems cost €60 to €100 per sq m due to additional floor preparation. Electric mat systems cost €30 to €60 per sq m. A bathroom electric mat costs €500 to €1,200 installed. A whole-house wet system in a 150 sq m new build costs €7,000 to €12,000 including manifold, pipes, and controls.
Yes, particularly when paired with a heat pump. Underfloor heating operates at water temperatures of 30 to 40 degrees, which matches the output of heat pumps perfectly, allowing both systems to run at peak efficiency. This combination is one of the most energy-efficient heating solutions available in Ireland today. Even with a conventional boiler, underfloor heating distributes warmth more evenly than radiators, which often means you can run the thermostat 1 to 2 degrees lower for the same perceived comfort.
It is possible but more complex and expensive than in a new build. Options include laying a low-profile wet system on top of the existing floor (raising the floor level by 30 to 50mm), excavating the existing floor to accommodate standard pipes beneath a new screed, or installing electric mats in individual rooms like bathrooms and kitchens. The practicality depends on your existing floor construction, ceiling height in the room below, and your willingness to accept a slightly raised floor level.
Tile (porcelain, ceramic, natural stone) is the best conductor of heat and the ideal partner. LVT and engineered wood are also fully compatible, with engineered wood performing best at thicknesses up to 18mm. Thick carpet with dense underlay (above 1.5 tog combined) insulates against the heat and significantly reduces the system's effectiveness. Solid hardwood is generally not recommended due to the risk of shrinkage, warping, and gaps developing over time from the constant heat below.
Underfloor heating is a slow-response system compared to radiators. A wet system embedded in screed takes 2 to 4 hours to bring a cold room up to temperature. Once the screed is warm, its thermal mass maintains a stable temperature with minimal additional energy. Electric mat systems beneath tiles respond faster, typically 30 to 60 minutes. The key is to programme the system with longer lead times rather than switching it on and off throughout the day.
Yes, this is very common in Irish homes. Many use underfloor heating in the ground floor extension or kitchen-living area and radiators upstairs. Both can run from the same boiler or heat pump, but the system must be designed with separate flow temperatures because underfloor heating runs cooler (30-40 degrees) than radiators (55-70 degrees). A mixing valve or buffer tank manages these different temperature requirements within one system.